As 9111 port used by Visualizer add on service. Changing the 9111 port to 9112 in Test Recorder doesn't work

HCL Volt MX Volt MX Forum
1
This thread was migrated from an old forum. It may contain information that are no longer valid. For further assistance, please post a new question or open a support ticket from the Customer Support portal.

After changing port for test recorder to 9112 and validating it, the test recorder window doesn't appear.

Only changing it to 9111 and restart of visualizer makes the test recorder window open.

But the device not connected error still shows

2

@Owen Ellison​ Can you help ?

3

@Hvwwy Roxewts​

Please validate below steps:

1)The device and system should be on the same network .

2)Connecting to vpn changes the IP address that visualizer normally picks .You can change the ipaddress that visualizer picks by disabling AutoDetect option.

Edit ->preferences->General->

Untick :AutoDetect System IP Address.

Enter your IP Address in "Static IP "field. (Snapshot attached)

After doing above steps,build the application.

Open the reorder window and launch the application.

Device should be connected.

if still facing the issue,after doing above steps,Please share the device logs.