HTTP Server: SSL handshake failure

As we enabled debug log we can see continue the error:

[1871128:000118-00007F92E9095700] 07-01-2021 19:18:53 HTTP Server: SSL handshake failure, IP address [xxx.xxx.xxx.xxx], Keyring [keyfile.kyr], [SSL Error: Network IO error], code [4165]
When testing the configuration at Qualy SSL Labs we get an A+ rating.
We are only have support for TLS1.2 and strong Cipher Suites.

How to get rid of this error?

Thanks for your information in advance.

Regards, Barend

Hi Barend.

If it's a Productive server, it shouldn't have Debug enabled.

That message only indicates that indeed, it was not possible to establish such SSL communication because you have disabled those weak ciphers.

Test and outdated sites / clients attempting to perform request using weak ciphers will indeed result in an Error (which is good from a security point of view).

So, you can disable debug and should not worry about this messages, if caring about security.

Regards, Elvis.

Hello @Barend Keijzer !

See the KB below reporting the same messages that you identified:

> KB0024380 - Error: "HTTP Server: SSL Handshake Failure..." with Error Code 4165

https://support.hcltechsw.com/csm?id=kb_article&sysparm_article=KB0024380

These messages now only occur when HTTP thread logging is enabled. If you do not want to see the messages, then disable thread logging.

Please mark this question as answered and helpful if your issue is resolved.

Regards!​

Rodrigo de San Vicente

Staff Software Engineer

Collaborative Workflow Platform

Hello Barend,

The reason for the error message is due to the fact when we enable http server thread logging. Being a Traveler server you might have enabled this for troubleshooting the issue as described in the below document on "User connectivity and password problems" OR may be HCL support has requested you to enable for troubleshooting an issue.

https://help.hcl-software.com/traveler/11.0.0/UserConnectivityProblems.html

To get rid of these error messages you can just issue the command on the Domino server console.

tell http debug thread off

More Details:

To enable logging of HTTP requests for a Domino server for the current HTTP session only, enter the following command on the server console:

"tell HTTP debug thread on"

When you restart the HTTP task, requests are no longer logged. You can also end request logging by entering the following command on the server console:

"tell HTTP debug thread off"

Using tell commands only lasts until HTTP is restarted. If you have set equivalent server notes.ini values for tell http debug thread all OR tell HTTP debug thread on then you should remove the below servers notes.ini debugs if present and then restart the Domino server.

HTTPEnableThreadDebug=1

HTTPEnablePostDataLogging=1

HTTP EnableResponseContentLogging=1

Thank you.

Regards

Shrikant J